Oil spill identification (NT CHEM 001)

Size: 297.79 KB
  • Report #: NT CHEM 001
  • Approved: February 1991
  • Hits: 0
  • Version: 2


The purpose of this NORDTEST Oil Spill Identification system is to establish identity or non-identity of a sample taken from a spill with samples taken from suspected sources. The system contains recommended methods for sample collection handling and analysis.

The samples in question are described by a variety of parameters. Identity or non-identity is established solely by comparing the analytical results, but any other relevant information that could identify the source should be evaluated in the report. The identification system is applicable to petroleum oils and the analytical results are intended to be used as evidence in court.

This system may involve hazardous materials, operations and equipment. It is not intended to address all the safety problems associated with its use. It is the responsibility of whoever uses this identification system to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


NT Methods | Chemistry


Nordtest is a trademark of Nordic cooperation in conformity assessment. The emphasis of Nordtest is to develop, promote and innovate Nordic test methods and pre-normative activity. Nordtest endeavours to remove technical barriers to trade and promotes the concept: “Approved once, accepted everywhere”.