Noise sources - sound power level: Engineering method - reference sound source, in situ (NT ACOU 070)

Size: 61.18 KB
Print
  • Report #: NT ACOU 070
  • Approved: November 1988
  • Hits: 0

Abstract

This NORDTEST engineering method specifies how to measure sound pressure levels produced at prescribed measurement points in the far or near field by the noise source under test and by a reference sound source.

The sound power level of the source under test is calculated from the measured values of the sound pressure level by using environmental corrections. These environmental corrections are calculated from the differences between the values obtained with a reference sound source and those given by its calibration. All calculations are carried out in 1/ 1 -octave or 1/3-octave bands.

Categories

Acoustic | NT Methods

Nordtest

Nordtest is a trademark of Nordic cooperation in conformity assessment. The emphasis of Nordtest is to develop, promote and innovate Nordic test methods and pre-normative activity. Nordtest endeavours to remove technical barriers to trade and promotes the concept: “Approved once, accepted everywhere”.